0 votes
Hello . I have the pandora tool box and I used to use it without any problem, but recently there is a problem that every phone I connect gets stuck in the part where I sent the log.
I tried with different phones, the same problem persists, the same problem exists on another laptop, and finally I changed the Windows computer and the problem is still there.
Selected model: Xiaomi Redmi Note 11S (Fleur)
Operation: Read Flash Info
Software version: 6.6

Host Power Off... OK
Switch virtual port to NONE... OK
Connect Type-C to HUB... OK
Host Power On... OK
Connect phone to [BOX] in BROM/PRELOADER Mode
Waiting for device... OK
Driver: [MediaTek Inc.,wdm_usb,MediaTek USB Port,usb2ser.sys,3.0.1504.0]
Device found at COM4 [BROM]
Open port... OK
Send start cmd... OK
Get HW code from device... 1066
Get sec config... OK [000000E7]
Active sec flags: [SBC SLA DAA]
Get HW & SW version from device... OK
HW VER: CA00, SW VER: 0000, HW SUB CODE: 8A00
Detect chip [MT6781]
Library Version [2]
Select platform... OK
Init BROM... OK
Force Charge... OK
Disable WatchDog Timer... OK
Force switch to BROM... OK
Host Power Off... OK
Switch virtual port to USB... OK
Connect Type-C to BOX... OK
Host Power On... OK
Waiting for device... OK
Read usbhost speed... HIGH
Read Device Descriptor...
Get VID/PID...0E8D/0003
Send start cmd... OK
Get HW code from device... 1066
Get HW & SW version from device... OK
HW VER: CA00, SW VER: 0000, HW SUB CODE: 8A00
Detect chip [MT6781]
Get sec config... OK [000000E7]
Active sec flags: [SBC SLA DAA]
Release testpoint
Advanced Bypass Security... OK
Waiting for device... OK
Read usbhost speed... HIGH
Read Device Descriptor...
Get VID/PID...0E8D/0003
Send start cmd... OK
Get HW code from device... 1066
Get HW & SW version from device... OK
HW VER: CA00, SW VER: 0000, HW SUB CODE: 8A00
Detect chip [MT6781]
Get sec config... OK [000000E7]
Active sec flags: [SBC SLA DAA]
Advanced Bypass Security... OK
Waiting for device... timeout
in General questions by (120 points)

2 Answers

0 votes
Hello. Enable in settings work via pc port and repeat.
by (204k points)
The use box usb port option is active, but I turned it off and connected the cable directly to the computer port, and it was fixed.
But why does it not work when I connect it to the box? Is the port box having a problem or is the problem something else?
We will fix this in some update.
Thank you for the quick response

I am waiting for the new update
0 votes

Even if the drivers seem fine, try reinstalling them. Sometimes drivers can be corrupted or out of space waves. Use the latest drivers from the Pandora toolbox website.

ago by (140 points)
...