Isp pin short

Question

Sir when ever i connect my easy jtag plus to my pc

My pin in ground becomes short with data0 cmd & clk

I was using isp to my Samsung a045f to remove frp then when i connect ground to the isp socket cmd clk Data0 all gets disconnected if i don't connect ground then all the lines r ok & connected

I tested it even without any socket directly from box & it shows short ground data0 cmd clk

If i check without connecting the box to pc it doesn't shows any short

Answer 1

If reverse tester pins - is it still shorted?

Comments

No if reverse then no short

But non of then isp now showing after im connecting cmd clk data0 all r showing red on pin tested & cmd error

---

Seems like bad soldering.

---

Anyway, if you sure that its hardware issue - return box for warranty repair/exchange (in case if you have warranty).

---

Im from Bangladesh seller doesn't gives us warranty  this box is banded on our country thats why i was seeking help im now trying on samsung j200h same even without ground line all lines r red on pin tester

---

Hello, to me show this problem isp sm 4350 moto g62 5g

"Initialize UFS Engine Fail. Code: -113/ERROR_UFS_UPIU_NOP_RESULT_FAIL"

---

What software you use?

---

EmmcManager

---

i jump r4 and r5, and i finish the isp, thank you.

---

Partition "SYSTEM" is Write Protected by RPMB config

Answer 2

When testing without connecting the box to the computer, there is no short, but when connecting, it means Poly Track that the JTAG box or ISP converter may be faulty. Check if any components on the JTAG box are burned or swollen.