"Card not found"

Question

I bought a Z3X BOX that has a "Z3x box with Sam activated" and I followed all the steps to download the shell, drivers and everything. The shell loads fine and it says that the Card is CONNECTED when I go into the Hardware wizard. It also says that the Samsung Tool Pro is already activated, so I don't see what the problem is, I tried running both the Shell and Samsung Tool Pro under adminstrator privileges, still nothing works. Help please?

Answer 1

If you have a problem - SMARTCARD not detected/Program Damaged while running software.

1. Try clean SMARTCARD pins. Try using another reader for SMARTCARD. Try reinstall drivers. Try to use another PC.
2. Disconnect all other boxes, dongles and try to use function repair dead card.

Try these steps:

1. Disconnect card
2. Run shell, Hardware wizard, Repair Dead Card should be available (because no card connected)
3. Connect card and then click Next (with Repair option selected)
4. Update card firmware and activate all products and close Wizard
5. Launch Samsung Tool

Answer 2

Install this bro click : HERE