0 votes
Hello . I have the pandora tool box and I used to use it without any problem, but recently there is a problem that every phone I connect gets stuck in the part where I sent the log.
I tried with different phones, the same problem persists, the same problem exists on another laptop, and finally I changed the Windows computer and the problem is still there.
Selected model: Xiaomi Redmi Note 11S (Fleur)
Operation: Read Flash Info
Software version: 6.6

Host Power Off... OK
Switch virtual port to NONE... OK
Connect Type-C to HUB... OK
Host Power On... OK
Connect phone to [BOX] in BROM/PRELOADER Mode
Waiting for device... OK
Driver: [MediaTek Inc.,wdm_usb,MediaTek USB Port,usb2ser.sys,3.0.1504.0]
Device found at COM4 [BROM]
Open port... OK
Send start cmd... OK
Get HW code from device... 1066
Get sec config... OK [000000E7]
Active sec flags: [SBC SLA DAA]
Get HW & SW version from device... OK
HW VER: CA00, SW VER: 0000, HW SUB CODE: 8A00
Detect chip [MT6781]
Library Version [2]
Select platform... OK
Init BROM... OK
Force Charge... OK
Disable WatchDog Timer... OK
Force switch to BROM... OK
Host Power Off... OK
Switch virtual port to USB... OK
Connect Type-C to BOX... OK
Host Power On... OK
Waiting for device... OK
Read usbhost speed... HIGH
Read Device Descriptor...
Get VID/PID...0E8D/0003
Send start cmd... OK
Get HW code from device... 1066
Get HW & SW version from device... OK
HW VER: CA00, SW VER: 0000, HW SUB CODE: 8A00
Detect chip [MT6781]
Get sec config... OK [000000E7]
Active sec flags: [SBC SLA DAA]
Release testpoint
Advanced Bypass Security... OK
Waiting for device... OK
Read usbhost speed... HIGH
Read Device Descriptor...
Get VID/PID...0E8D/0003
Send start cmd... OK
Get HW code from device... 1066
Get HW & SW version from device... OK
HW VER: CA00, SW VER: 0000, HW SUB CODE: 8A00
Detect chip [MT6781]
Get sec config... OK [000000E7]
Active sec flags: [SBC SLA DAA]
Advanced Bypass Security... OK
Waiting for device... timeout
in General questions by (120 points)

1 Answer

0 votes
Hello. Enable in settings work via pc port and repeat.
by (201k points)
The use box usb port option is active, but I turned it off and connected the cable directly to the computer port, and it was fixed.
But why does it not work when I connect it to the box? Is the port box having a problem or is the problem something else?
We will fix this in some update.
Thank you for the quick response

I am waiting for the new update
...