eMMc tool suite version 1.6.6.0 error

Question

eMMc tool suite version 1.6.6.0 shows all dots green even without the IC in the socket. What would be the problem?

Answer 1

Hello. Check with other socket to be sure its socket or box problem.

Comments

Checked only the box without the red socket. It shows dots in red color. I think the box is ok.

 

---

So change socket in this case if you sure that box is ok.

---

And I checked with only the base plugged into the box. Again it showed green dots. I think this red color base has a problem. See the photo.

 

---

Please help me with this. I recently purchased this item. Not even one month now.

---

Ask seller for warranty repair/exchange.

---

I contacted the seller. They said if I see R50 is on the board as in the photo, no problem. I see R50 on the board. But the same problem. Your software shows dots green even without any IC connected. Check the photo. I noticed this fault occurs only when the easy EMMC port is connected. The other 3ports seem working correctly.

Answer 2

This error message suggests that there is a problem Tunnel Rush with the connection between the program and the eMMC chip.

There are a few possible reasons why this might be happening:

The eMMC chip is not properly inserted into the socket.
The socket is faulty.
The eMMC chip is damaged.
The there is a problem with the eMMC tool suite software.