0 votes

eMMc tool suite version 1.6.6.0 shows all dots green even without the IC in the socket. What would be the problem?

in Easy JTAG by (120 points)

4 Answers

0 votes
Hello. Check with other socket to be sure its socket or box problem.
by (205k points)

Checked only the box without the red socket. It shows dots in red color. I think the box is ok.

 

So change socket in this case if you sure that box is ok.

And I checked with only the base plugged into the box. Again it showed green dots. I think this red color base has a problem. See the photo.

 

Please help me with this. I recently purchased this item. Not even one month now.
Ask seller for warranty repair/exchange.

I contacted the seller. They said if I see R50 is on the board as in the photo, no problem. I see R50 on the board. But the same problem. Your software shows dots green even without any IC connected. Check the photo. I noticed this fault occurs only when the easy EMMC port is connected. The other 3ports seem working correctly.

0 votes

This error message suggests that there is a problem Tunnel Rush with the connection between the program and the eMMC chip.

There are a few possible reasons why this might be happening:

The eMMC chip is not properly inserted into the socket.
The socket is faulty.
The eMMC chip is damaged.
The there is a problem with the eMMC tool suite software.

by (220 points)
0 votes

This tool helps people shorten the time to complete work.  Connections NYT

by (180 points)
0 votes

I cannot believe how generous you are in providing me with such a large amount of knowledge. I want to express my appreciation for the fact that you are a source of motivation for me. gacha life

by (140 points)
...